Electrical Fault Finding in Accrington

Electrical fault finding in Accrington for tripping breakers, dead sockets and flickering lights. We test circuit by circuit to find the cause, explain what we have found in plain terms, then repair it. Same day response and emergency callouts.

Home > Electrician > Electrical Fault Finding

Common Causes of a Tripping Breaker

Most trips come from one of three things: water where it should not be, a failing appliance, or damaged cable. Immersion heaters, outside sockets and older shower units are frequent culprits. Unplugging everything and switching back on tells us a lot before we open anything up.

More Information

How We Trace a Fault

We split the circuits and test each one with an insulation tester, which shows where current is leaking to earth. That narrows the fault down to one section of cable or a single accessory. Only then do we lift a board or open a wall.

Faults That Need Looking At Today

Burning smells, scorch marks around a socket, a faceplate that feels warm or a breaker that will not stay on at all need attention the same day. Switch that circuit off at the board and leave it off. Then call us and we will come out.

Our reviews

STILL NOT SURE?

Frequently Asked Questions

Why does my RCD keep tripping in the middle of the night?

Night trips usually point at something on a timer, most often an immersion heater, storage heater or freezer. Damp getting into an outside socket does the same after heavy rain. We test the circuits to find which one is leaking rather than switching things off and hoping.

How long does electrical fault finding take?

Most faults are found within one to two hours. Intermittent ones take longer, because the problem has to be happening to be measured. We charge for the time on site and tell you where we have got to before going further, so nothing runs on without your say so.

Can you find a fault without damaging my walls?

Nearly always. Testing narrows the fault to a short run of cable or one accessory, so we open a small area rather than a whole wall. Where a buried cable has failed, it is often easier to run a new one on a fresh route than chase out the old one.

About us

Fault finding is testing, not guesswork. The instruments tell us where the leak or the break is, and experience tells us where to look first. We explain what we have found and what it will take to put right, then repair it and retest the circuit before we go.