Electric vehicle charging station contractor in Accrington

We are an electric vehicle charging station contractor in Accrington fitting home and business charge points. We check your supply and fuse box first, install the unit near where you park, then test and certify it. Repairs and replacements too.

Home > Electric vehicle charging station contractor

Our Services

EV charger installation starts with a check of your incoming supply and fuse box, because the charger needs its own protected circuit. We then fit the unit and set it up on your app. Most installs take a few hours. See our EV charger installation page for more.

A home EV charger fills the car overnight far faster than a three pin plug, and off peak electricity brings the running cost down. We fit units on the wall or on a post if you park away from the house. Our home EV charger installation page explains the options.

Workplaces and car parks need chargers that stand up to daily use and can bill drivers properly. We look at your supply capacity first, then plan the cable routes and mounting points. Read the commercial EV charger installation page to see how a site install works.

A charger that will not start, keeps cutting out or shows a fault light is usually fixable without a new unit. We test the supply, the earthing and the charger itself before deciding. Our EV charger repair page covers the faults we see most often.

Early charge points are slow, and some makers no longer support their own units. Swapping to a newer model gives faster charging and a working app. The existing cable can often be reused. See our EV charger replacement page for what is involved.

Three phase supplies allow much faster charging and suit vans, fleets and busy sites. We check what your supply can carry, then install and balance the unit across the phases. Our three phase EV charger installation page has the detail.

Our process

Step 1

Free consultation

We discuss your needs and recommend the best solution for you.

Step 2

We sort it for you

We handle everything from start to finish so you do not have to worry.

Step 3

Inspection

We check everything is completed properly and you are fully satisfied.

Frequently Asked Questions

How long does it take to install an EV charger in Accrington?

Most home installs take three to four hours. The time goes on running the cable from the fuse box to the parking spot and fitting the protection the charger needs. If the fuse box has no room, that adds a little. We confirm the timing when we quote.

Do I need to upgrade my fuse box for an EV charger?

Sometimes. The charger needs its own way in the board with the right protection. If your board is full or has no RCD protection, it will need changing first. We check this on the visit before quoting, so you know the full picture from the start.

Can you fit an EV charger if I have no driveway?

It depends on where you can park. A charger has to be reachable by the cable without it crossing a public footpath. If parking is off to the side, a post mounted unit often works. Send us a photo of the parking spot and we will tell you what is possible.

About us

Mather Electrical Contractors installs EV charge points for drivers and businesses around Accrington. Charger work is electrical work first, which is why we check the supply, the earthing and the fuse box before anything is mounted on a wall. The install is tested and certified in the same way as any other circuit, and the paperwork comes with it.

  • NVQ Level 3 qualified in Electrical Installation

  • 2391 Testing and Inspecting certified

  • Free quotes with no obligation

  • Same day response across Accrington

  • Emergency callouts, seven days a week

Our reviews